Similar issues, ran into the bug R1D2 mentioned. Try this: - Power Cycle the switch - Make 802.1q updates to the config - Go to the main menu on the left and click on Save Config and confirm - Power...

Thanks for the reply, you are probably correct. After I posted I noticed that if I unplug the fiber media converter then the issue stops.

Hello, I also found the setup screens for the VLAN a bit quirky. As you said, cannot remove ports from VLAN 1 until a another VLAN is set up. I've been running a 802.1q network with the SG108E...

Model : Hardware Version : Firmware Version : ISP : Hello, our home has three buildings and I'm using 802.1q on SG108E's to connect over fiber between buildings. This has worked very well for about...