I have tried again to restore both devices to factory, to use the fast configuration and in region to use the option "Test_mode" and now it works without problems. I do not know if it was because of...

R1D2 wrote The CPE is not in Client mode, it's in Bridge or Repeater mode. In Client mode there is no such submenu: Anyway, ping works for me in Client and Bridge modes, with /16 subnet mask, WDS On...

R1D2 wrote Check that the subnet masks of both CPEs are the same. Are you really needing a /16 network? Next, try to ping the CPE#2 from CPE#1 and vice versa via built-in ping. If this works, the...

R1D2 wrote You need one CPE in AP mode (make sure it really is AP mode, but not AP router mode) and one CPE in client mode. It's not important which one is the AP and which one is the client, but...

tacman7 wrote Seems like your first setup should work. Are you just networking these computers or are you sending the internet out to the client 510 also? Bridge mode would be used to bridge between...

Model : Hardware Version : Firmware Version : ISP : First of all, sorry for my precarious English I have 2 CPE510, I need to connect 2 points wirelessly, but that the pc's of both points look at each...