Used PuTTY to connect to the CLI and checked all settings with the various SHOW commands documented in the CLI user guide. All this did was use the CLI to confirm the standalone Web interface...

@Clive_A I'm using the two VLANs as the source and destination networks in the LAN to LAN ACL. It is as though there is a default pass ANY before the LAN to LAN blocks. I haven't tried the CLI to see...

The Access Control entries were created to block LAN to LAN access but they didn't seem to achieve anything. Worst comes to the worst I can stop using the standalone mode and install Omanda software...

Basic configuration is three WAN ports (WAN, WAN/LAN1, WAN/LAN2) and two LAN Ports. I wish to achieve a LAN for secure traffic (e.g. PCs, etc) on Port 4 while traffic on Port 5 is an isolated LAN for...