I have just bought the above only to find out that it doesn't support multiple Public IP addresses. I have Fibre to the Premises and 4 public static IP addresss No problem with this and my current rou

Team, Suggestion (assuming this is not possible within the current firmware): Allow customers to operate the router without using NAT. Meaning allow the device to behave as a special router with firew

Hi, Just noticed this in my controller software: whilst the Cisco 887 it's connected to says this: I think the controller is reporting this incorrectly, as the cisco would alert if there was a mismatc

Updated on 7 May 2022: Thank you all for your valuable feedback on the Controller v5.2.4 beta. Official release for Omada Software Controller v5.3.1 is now available. For more details, please refer to

I have an Er605 router managed by Omada controller 0C200 I have 5 usable WAN IP Addresses. lets say x.x.x.2 - x.x.x.6. Router setup as x.x.x.2 / 255.255.255.248 / GW x.x.x.1 I need x.x.x.2 to NAT to o

My router is provisioned from the OC200 controller and it seems to take away some capabilites that the router with multiple WAN connections should have. I need to bring in multiple IP address from our