ocbroadbandLV2Online
Following: 0Followers: 0
Forums/ Routers
By ocbroadband 2024-08-28 14:59:44

ER605 - Custom Port Access

Hello, Goal: I want to allow only specific host addresses to be able to access specific ports opened up by NAT. My device is in stand-alone mode, and I have some ports that are setup under NAT->Virtua
Forums/ Requests & Suggestions
By ocbroadband 2024-08-05 20:55:22

Static Routing Option(s)

Hello, To better utilize the TPLink Omada line of routers to fit within the business models, I'm wanting to be able to funnel traffic, either full or split, to specific locations that are interconnect
Forums/ Routers
By ocbroadband 2024-06-29 03:38:16

Mutlisite Mesh Ring via IPSEC - OSPF setup

Hello Gurus, I'm trying to setup a small ring between 3 sites with 3 ER605s connected to a single ISP at each site. I have the VPN tunnels established and can reach the subnets at each site from the o
Forums/ Routers
By ocbroadband 2023-11-10 21:52:15

ER605 - IPSec VPN / Remote Subnets & Adopting ER605 to remote OC200

Hello, I have an IPSEC connection setup between a ER7206 & ER605 in the following design. ER7206 (Hub) <-> ER605 (Spoke) Connections work fine to each other to the primary LAN over the IPSEC connectio
Forums/ Routers
By ocbroadband 2023-05-15 14:09:52

NAT filter by TOD

Is it possible to restrict inbound NAT rules by TOD? I want to only allow certain NAT's during certain hours. I can't seem to figure out how to tie a Time Range profile to the NAT configuration, if th
Forums/ Requests & Suggestions
By tekneon 2021-10-07 00:24:07

Request: ACL Rule for established and related traffic

It is very painfull to setup good ACL rules without an "Established and Related" traffic option. Here is another thread about this request : https://community.tp-link.com/en/business/forum/topic/25286