Hello. Quick question as to best practice for inital setup of OMADA hardware. What is the best practice here? connect all devices (including controller) then go straight to controller and initiate dep

Hey, I am setting up a SX3008F Switch as my 10GBe Backbone Switch replacement and would like to use it as a DHCP Server as well. It'll replace another standalone dnsmasq DHCP server in my network. Bas

I need to configure my Wi-Fi network so that the different APs have the same name so that when moving the signal never cuts out or I have speed problems. Currently the APs are connected by cable to a

It would be nice if the UI for the downlink port edits on the AP worked like the UI for the switch ports so you can just assign a profile and not specific VLAN settings. The EAP 615 UI is better, but

hi tplink, i'm having trouble with how the map shows the location of my switches. if you refer to the image image below, before this is the setup. however i since change the sx3008f to be the main, in

Hi, Network hardware: 1.28PORT switch- SG2428P v5.20 2.Router- ER605 v2.0 3. Hardware Controller - OC200 4. AP - 3X EAP235-Wall(US) v1.0 5. AP - 2X EAP265 HD(EU) v1.0 VLANs: 1. VLAN_1 - 192.168.0.x is