Hello Guys, I'm trying to make my router and DVR to be accessible remotely. But in the TP-Link remote access section when I insert Port 80 and subnet mask 255.255.255.255 I get the error 14007 try aga

Hello, I have a TL-R600VPN and I'm trying to configure an access control rule to allow a set of systems (192.168.1.5-1.92.168.1.10) to only be able to access the internet. This is essentially the equi

I would like to discard unknown IPv4 multicast traffic because I often have situations when there are groups with no members. I cannot enable it for IPv4 only, because the UI/CLI doesn't allow me to.

Hi, i've setup my 470 and everythong is ok, except traffic statics ip based. Under Status - Traffic Statistics - Ip Statistics i have enablaed "Enable Ip Statistics" and i have setup 192.168.77.0 / 25

Just looking at the ER6020 for setting up a simple VPN for our company. We have a mix of PC and Mac's that need access. Currently we are using OpenVPN on the PC's and on the Mac we are using Tunnelbli

this router has lan port with POE ? if no, can i buy TP-Link TL-POE10R PoE Splitter to resolve problem ? then i must buy particolar lan cable ? thank you very much