EAP225-Outdoor doesn't like Cat6 cable?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

EAP225-Outdoor doesn't like Cat6 cable?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
EAP225-Outdoor doesn't like Cat6 cable?
EAP225-Outdoor doesn't like Cat6 cable?
2019-09-12 16:22:20
Model: EAP225-Outdoor  
Hardware Version: V1
Firmware Version: Current

Installed about 10m of Cat6 cable for an EAP225-Outdoor but can't get AP to work. It powers on and broadcasts SSID but does get an IP address from the router. Swapped it for a standard EAP225 and this works just fine, so no fault with the cable. Took the EAP225-Outdoor back indoors and connect to router with cat5 patch leads and this works just fine. 

 

Any ideas as to why it doesn't work with the cat6 cable?

 

Paul B

  0      
  0      
#1
Options
4 Reply
Re:EAP225-Outdoor doesn't like Cat6 cable?
2019-09-13 13:59:49 - last edited 2019-09-13 17:37:36

Paul_B1 wrote

Any ideas as to why it doesn't work with the cat6 cable?

 

Check your cable for loose contacts. I use CAT.6 S/FTP cable for connecting EAP225-Outdoor when setting up devices in the lab. For outdoor installations, we usually use even UV-persistant CAT.5e outdoor cables with a ground-wire, since grounding is an essential requirement for any outdor device. Photo below is from a Pharos installation, but we also use this cable with EAP225-Outdoor. Note the additional ground wire:

 

 

 

༺ 0100 1101 0010 10ཏ1 0010 0110 1010 1110 ༻
  0  
  0  
#2
Options
Re:EAP225-Outdoor doesn't like Cat6 cable?
2019-09-15 17:27:23

@Paul_B1 

 

I'm using cat 6 outdoor type cable 80meters and 20 meters on my 2 eap225-outdoor without any problem.

  0  
  0  
#3
Options
Re:EAP225-Outdoor doesn't like Cat6 cable?
2019-09-15 17:34:12
In the end I just replaced the AP with a new one and that worked first time with the existing cabling so I'm guessing the unit is somehow faulty. I'll just send the original one back.
  0  
  0  
#4
Options
Re:EAP225-Outdoor doesn't like Cat6 cable?
2021-11-17 01:37:48

@Paul_B1 

 

there are times when the connectors don't match up or a crimp on end warps the plastic a little and one of the pins does not make good contact.  because power and communications does not use the same pairs you can have one with out the other. 

 

another case i have seen when someone is using an ez-trough connector on a cable and plugging it into a shielded connection there is a greater chance of shorting out some of the pairs.

 

scottb.ca

  0  
  0  
#5
Options

Information

Helpful: 0

Views: 2283

Replies: 4