TL-R600VPN - Force Connection to L2TP Client

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

TL-R600VPN - Force Connection to L2TP Client

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TL-R600VPN - Force Connection to L2TP Client
TL-R600VPN - Force Connection to L2TP Client
2020-02-01 17:36:34 - last edited 2021-04-19 11:32:43
Model: TL-R600VPN  
Hardware Version:
Firmware Version:

I have an L2TP client setup on this VPN router that establishes a connection and everything works fine in terms of all traffic hitting the VPN. The problem is that if something goes wrong with the VPN, then the route table gets adjusted and everything is routed through WAN1. I want all traffic to be forced through the VPN, and if the VPN is not working to just not route through anywhere else. 

 

TCHI = VPN

 

 

VPN config error (removed from route table)

 

 

 

Please let me know if any other information is necessary.  I appreciate the help!

 

 

  0      
  0      
#1
Options
1 Reply
Re:TL-R600VPN - Force Connection to L2TP Client
2020-02-04 10:33:16 - last edited 2021-04-19 11:32:43

@cplusplus1 

 

If R600VPN be a L2TP VPN client,it should need to set remote subnet. The router will create a routing according to the remote subnet. But I did not see this routing in your screenshot. Maybe you set the router as VPN server? I think cannot make VPN server to send all traffic to VPN client.

  0  
  0  
#2
Options