Business Community > Pharos Wireless Bridges > Extend WiFi to apartment
< Pharos Wireless Bridges

Extend WiFi to apartment

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Extend WiFi to apartment

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Extend WiFi to apartment
Extend WiFi to apartment
2020-10-11 10:42:55 - last edited 2020-10-20 08:27:47
Model: CPE210  
Hardware Version:
Firmware Version:

Hi,

 

I've put up two CPE 210 to extend my WiFi coverage to an apartment in our barn. The first is configured as an AP and the second I've tried with basically all modes but when I connect to it I get the "connected but no internet" message from the phone of laptop I've connected. 
 

Would really appreciate any help on how to solve this.

 

Thanks!

  0      
 
  0      
 
#1
Options
1 Accepted Solution
Re:Extend WiFi to apartment-Solution
2020-10-13 03:16:44 - last edited 2020-10-20 08:27:47

Dear @Huzell,

 

The first is configured as an AP and the second I've tried with basically all modes but when I connect to it I get the "connected but no internet" message from the phone of laptop I've connected. 

 

Please ensure that you have Internet access from the first CPE AP firstly.

The second CPE is suggested to set as Client mode, you may refer to the guide below to configure it.

https://www.tp-link.com/support/faq/727/

 

If it is but you get no internet access, please check the IP info obtained on the laptop, verify whether the DHCP is enabled on the laptop.

How to find IP address of your computer, https://www.tp-link.com/support/faq/838/

 

If the DHCP is NOT enabled on the laptop, please configure the laptop with Obtain IP address automatically or Using DHCP.

https://www.tp-link.com/support/faq/14/

>> Omada EAP Firmware Trial Available Here << *Try filtering posts on each forum by Label of [Early Access]*
Recommended Solution
  0  
  0  
#2
Options
1 Reply
Re:Extend WiFi to apartment-Solution
2020-10-13 03:16:44 - last edited 2020-10-20 08:27:47

Dear @Huzell,

 

The first is configured as an AP and the second I've tried with basically all modes but when I connect to it I get the "connected but no internet" message from the phone of laptop I've connected. 

 

Please ensure that you have Internet access from the first CPE AP firstly.

The second CPE is suggested to set as Client mode, you may refer to the guide below to configure it.

https://www.tp-link.com/support/faq/727/

 

If it is but you get no internet access, please check the IP info obtained on the laptop, verify whether the DHCP is enabled on the laptop.

How to find IP address of your computer, https://www.tp-link.com/support/faq/838/

 

If the DHCP is NOT enabled on the laptop, please configure the laptop with Obtain IP address automatically or Using DHCP.

https://www.tp-link.com/support/faq/14/

>> Omada EAP Firmware Trial Available Here << *Try filtering posts on each forum by Label of [Early Access]*
Recommended Solution
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 909

Replies: 1

About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.