EAP660HD bad performance
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Seems doing some iperf3 tests on wifi5 speed is very low, on wifi 6 it also decreased - previously ~800 Mbits/sec was no problems. Now speed on wifi6 ony ~ 500 Mbits/sec and on wifi5 it start from 60 and increases after several tests to ~260Mbits/sec. I got better tests with EAP265HD........
I have 2 x EAP660HD in my house, on 5 GHz channel width 80MHz and two seperate channels 48 + 36
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
already tried to decrease power on 5 GHz, same results....
- Copy Link
- Report Inappropriate Content
very disappointed in performance, my old Asus which can do 300 Mbits performs better then this AP in terms of wifi5
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
For fun, please try switching the 5.8GHz channel width from 20/40/80 to 80MHz only and then re-test. Then switch back from 80MHz to 20/40/80 and re-test.
I've found that certain versions of EAP225V3 and EAP245V3 firmware handle the client BW negotiations better/worse than others. I'm curious if the EAP620/660 behaves similarly.
Also keep in mind this is the initial public version of the 620/660 software (I think) so I'm sure there are many bugs to still work out.
- Copy Link
- Report Inappropriate Content
But client which I use for testing is connected to 80, and I can see this from the client.
- Copy Link
- Report Inappropriate Content
Got new wifi adapter in PC, seem iper3 works fine comparing with my phone - on PC ~ 500 Mbits/sec (on wifi5 with 2x2 card), phone only ~300 Mbits/sec. Seems all fine with performance.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 1
Views: 2058
Replies: 6
Voters 1
