EAP115 cannot connect to its SSID to set up

EAP115 cannot connect to its SSID to set up
EAP115 cannot connect to its SSID to set up
Monday
Model: EAP115
Hardware Version:
Firmware Version:

Just bought this in UK.

 

I have powered it up with its pwer supply yet I cannot connect to its SSID to configure. All devices that try and connect say DHCP failure. This is without any network cable plugged in. 

 

I have reset it but before I send it back any ideas please?

 

Dave

0
0
#1
Options
3 Replies
Re:EAP115 cannot connect to its SSID to set up
Yesterday
Not sure but some ideas... - I suppose you connected via (PoE ) cable and using the correct port on the EAP115? - Have you used the app to configure things correctly? - If you have both your ISP router and AP with DHCP enabled, this might give issues. Make sure the EAP115 has DHCP disabled if so. hope it helps
0
0
#2
Options
Re:EAP115 cannot connect to its SSID to set up
Yesterday

@DieterV. 

 

Thank you. I went back to it this morning and managed to connect by changing the wi-fi settings on my phone to connect via static IP address in the range 192.168.0.*** which is the range the EAP115 uses.

 

Once connected I could alter the settings and integrate it into my network.

 

Cheers,

 

Dave

0
0
#3
Options
Re:EAP115 cannot connect to its SSID to set up
23 hours ago

@ballibeg Just make sure the AP doesn't use DHCP then since otherwise it would have received a dynamic IP address in that range in the first place (being a client of the network, receiving the IP from your router most likely).

 

If not it might conflict towards other devices anywhere in the future.

0
0
#4
Options