Omada Controller Version : 4.3.5 (run in docker on Synology NAS)

 

TL-R605 Hardware version: 1.6

TL-R605 Firmware version: 1.0.1 build 20210113 rel.35074

 

EAP225 Hardware version: (US) v3.0

EAP225 Firmware version: 5.0.3 Build 20210316 Rel. 67358

 

I have the above as my home network.  When I sign into my omada controller on my synology NAS, I was able to adopt everything and get everything setup and working!  I really enjoy this as an upgrade from an older Linksys router that has long since been abandoned by Linksys.  I really like the system and interface.  The only thing that I can't seem to figure out at the moment is the firewall.  

I go to the settings > network security > firewall and get the screen below.  

 

 

 

I'm not sure if I'm doing something wrong, or if I have missed a configuration step somewhere that's not allowing me to configure the firewall.  Or is it possible my TL-R605 doesn't support that yet and will be released in a later firmware update?  I have downloaded the latest firmware available from what I'm seeing on the version 1.6 support download page.  In the product documentation, everything I'm seeing indicates I should have access to that.  Any advice, tips, tricks, documenation for me to read through, etc, would be greatly appreciated!  Also if this is in the wrong section, just let me know and I can delete this and re-post in the correct section.