Ping between two hosts on seperate vlans using l3 interface

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Ping between two hosts on seperate vlans using l3 interface

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Ping between two hosts on seperate vlans using l3 interface
Ping between two hosts on seperate vlans using l3 interface
2021-10-08 14:05:33
Model: TL-SG3428  
Hardware Version: V2
Firmware Version: 2.0.1 Build 20210131 Rel.44230

Hi,

 

I have two vlans on this switch in which I'd like to be able to communicate between two hosts on their respective vlans.

I have subnet on one vlan

192.168.0.0

and subnet:

192.168.10.0

on the other vlan

My goal is to be able to ping from host 192.168.10.2 to host 192.168.0.101

 

So I created two virtual interfaces on L3:

192.168.0.1

255.255.255.0

and

192.168.10.1

255.255.255.0

 

The problem I'm having is that 192.168.0.1 says the status is "up" but the 192.168.10.1 says the status is "down" and I cannot ping from 192.168.10.2 to 192.168.0.101.

I tried rebooting the switch after I set these interfaces but I still get this problem.

 

Is this the best way to go about this on this switch? Any help will be greatly appreciated.

  0      
  0      
#1
Options
1 Reply
Re:Ping between two hosts on seperate vlans using l3 interface
2021-10-09 10:25:48

Dear @dusweave,

 

dusweave wrote

The problem I'm having is that 192.168.0.1 says the status is "up" but the 192.168.10.1 says the status is "down" and I cannot ping from 192.168.10.2 to 192.168.0.101.

I tried rebooting the switch after I set these interfaces but I still get this problem.

 

Please confirm that you can ping other devices in the same VLAN network first.

If it cannot ping either, please check the firewall settings on the devices, ensure they are not blocking the ping requests.

>> Omada EAP Firmware Trial Available Here << *Try filtering posts on each forum by Label of [Early Access]*
  0  
  0  
#2
Options