EAP245 Omada Controller - How to remove wireless B and G on 2.4Ghz?

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
EAP245 Omada Controller - How to remove wireless B and G on 2.4Ghz?
EAP245 Omada Controller - How to remove wireless B and G on 2.4Ghz?
2021-12-07 17:53:53 - last edited 2021-12-08 14:26:37
Model: EAP245  
Hardware Version: V3
Firmware Version: 5.0.1

Hi there,

 

I'm using several EAP245 access points with the Omada software controller v4.4.6.

 

Previously I was able to setup all the AP's in standalone mode and I can remove wireless B and G from the 2.4Ghz band.  I'd like to do the same using the Omada controller for all the AP's but there doesn't seem to be a way to do it.  I can enable 2.4Ghz or 5Ghz but I can't set anything more specific.

 

Is it not supported with the Omada software controller?  Or did I miss something?

 

Appreciate any help anyone can provide.

 

Thank you!

 

  0      
  0      
#1
Options
1 Accepted Solution
Re:EAP245 Omada Controller - How to remove wireless B and G on 2.4Ghz?-Solution
2021-12-08 07:46:21 - last edited 2021-12-08 14:26:37

@SuperCoolYolo 

 

 

I guess this below things that you said, right?

 

 

Recommended Solution
  0  
  0  
#2
Options
2 Reply
Re:EAP245 Omada Controller - How to remove wireless B and G on 2.4Ghz?-Solution
2021-12-08 07:46:21 - last edited 2021-12-08 14:26:37

@SuperCoolYolo 

 

 

I guess this below things that you said, right?

 

 

Recommended Solution
  0  
  0  
#2
Options
Re:EAP245 Omada Controller - How to remove wireless B and G on 2.4Ghz?
2021-12-08 14:26:31

@Virgo 

 

Thanks for your response Virgo.  I believe you are correct, that was the setting that should help me achieve my goal of preventing clients from connecting on wireless B and G modes.

 

It's unfortunate that the setting is hidden under those configuration options.  It is not easily visible.  I hope TP-Link can change the UI to make it more clear.

 

Again, thank you for your help! 

  0  
  0  
#3
Options