Setup a printer in ER605 load balancing / VPN router

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Setup a printer in ER605 load balancing / VPN router

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Confluence

2022-02-28 01:47:22 - last edited 2022-02-28 06:14:36

Posts: 5

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2022-02-28

Setup a printer in ER605 load balancing / VPN router

2022-02-28 01:47:22 - last edited 2022-02-28 06:14:36

Model: ER605 (TL-R605)

Hardware Version:

Firmware Version:

I have two GPON Wifi ONTs from two ISPs connected to WAN ports of the ER605 for load balancing.

A switch is connected to the ER605. I have a network printer hooked up to the switch. The printer prints when client connected through LAN.

How do I print from this printer if I connect wirelessly to any of the two GPON Wifi ONTs. Is there any way out to print using these Wifi ONTs and WITHOUT adding any additional Wifi Access Point.

Please Guide. Thanks in advance!

Rgds

1 Reply

Somnus

LV5

2022-02-28 07:53:08

Posts: 1212

Helpful: 221

Solutions: 72

Stories: 0

Registered: 2021-06-14

Re:Setup a printer in ER605 load balancing / VPN router

2022-02-28 07:53:08

@Confluence I don't think it is possible. ER605 is an NAT router doesn't have classic routing mode. A managed switch could be more suitable for your case, to do routing between the three local network. However a switch may not have some features that ER605 has.

Setup a printer in ER605 load balancing / VPN router

Setup a printer in ER605 load balancing / VPN router

Information

Voters 0

Tags