EAP610 v1.0 "потеряла" линк.

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

EAP610 v1.0 "потеряла" линк.

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
EAP610 v1.0 "потеряла" линк.
EAP610 v1.0 "потеряла" линк.
2022-05-02 08:54:27
Model: Adapter  
Hardware Version: V1
Firmware Version: 1.0.3 Build 20210806 Rel. 64734

Добрый день. EAP610 v1.0 проработала какое-то время по проводу, а потом перешла в режим isoleted, после этого получается подключить ее только по wifi от другой ТД EAP610 v1.0. Думал проблема в кабеле, подключил ее напрямую к коммутатору TL-SG2428P v4.0, но проблема осталась. Сбросил ее до заводских настроек, но и это не помогло. Скажите, это какой-то "железный" дефект?

  0      
  0      
#1
Options
3 Reply
Re:EAP610 v1.0 "потеряла" линк.
2022-05-03 09:33:49

  @Anzic 

 

It is recommended to check the IP address of the EAP and the IP address of the controller, perhaps there is a problem with communication.
The Isolated status is explained in the diagram below.


It is recommended that you reset the EAP and reconfigure the mesh.

 

Generally, restarting the EAP and rebooting the controller will solve the problem.

The reset hole is on the EAP, not on the POE adapter, and if successful you will see a change in the lights on the EAP.

Just striving to develop myself while helping others.
  0  
  0  
#2
Options
Re:EAP610 v1.0 "потеряла" линк.
2022-05-03 11:22:16
I have tried resetting the hotspot and setting it up again. But even so, it still connects only via wifi. the switch shows that the port transmits POE, but there is no link. I also tried to connect an access point through a POE injector - the result is the same, the access point is loaded, but the link does not appear.
  0  
  0  
#3
Options
Re:EAP610 v1.0 "потеряла" линк.
2022-08-01 11:36:47 - last edited 2022-10-13 10:54:28

EDIT

  0  
  0  
#4
Options