Controller reports that my ER605 WAN port is running at half duplex

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Controller reports that my ER605 WAN port is running at half duplex

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Controller reports that my ER605 WAN port is running at half duplex
Controller reports that my ER605 WAN port is running at half duplex
2022-05-25 14:42:43
Model: ER605 (TL-R605)  
Hardware Version: V1
Firmware Version: 1.2

Hi,

Just noticed this in my controller software:

 

 

whilst the Cisco 887 it's connected to says this:

 

 

I think the controller is reporting this incorrectly, as the cisco would alert if there was a mismatch.

I don't see anywhere in the software to set the duplex on the WAN port, assume it's just auto negotiated, can anyone confirm please?

Thanks

  0      
  0      
#1
Options
1 Reply
Re:Controller reports that my ER605 WAN port is running at half duplex
2022-05-26 09:38:01

  @pcb1962 

 

It may just showing wrong, as you said, the controller mode can not change the half/full or auto.
You can try to re-adopt it.
Or use the router in Standalone mode to see if it also shows half duplex?

Just striving to develop myself while helping others.
  0  
  0  
#2
Options