Portal picture "too large" message for a pic of 600KB

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Portal picture "too large" message for a pic of 600KB

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Portal picture "too large" message for a pic of 600KB
Portal picture "too large" message for a pic of 600KB
2022-11-23 09:10:18 - last edited 2022-11-23 09:12:23
Model: EAP245  
Hardware Version: V3
Firmware Version: 5.0.4 Build 20211021 Rel. 57494

Hello ! I have several EAP 245 and a Omada Controller 4.4.6 on Raspberry pi 4. I was going to set up a portal, but a nice picture. But then, I keep getting an error message, that the picture has to be smaller than 2MB. But I reduced and reduced and it's about 600KB now, I still get the same message. I would appreciate if someone could please tell me what is causing this.

 

p.s. the error message shows up when I click "Apply". When I click "Choose" and choose the pic, it says "upload succeeded".

  0      
  0      
#1
Options
2 Reply
Re:Portal picture "too large" message for a pic of 600KB
2022-11-24 07:58:50

  @doremifajb 

 

Try upgrading the firmware version of controller to V5 to test.

Just striving to develop myself while helping others.
  0  
  0  
#2
Options
Re:Portal picture "too large" message for a pic of 600KB
2022-11-24 15:06:11

  @Virgo Thank you for your reply ! Now I tried with another pic, with about 400KB, to see if it might actually work...  it did !! So I reduced my original pic further down to 550KB, then, interestingly, it did work ! I don't understand why 660 is not OK and 550 is OK, perhaps there is some problem with size-detection ? In any case, it does what I want to, so I'm not going to upgrade the controller..... Thanks anyway !!

  2  
  2  
#3
Options

Information

Helpful: 0

Views: 241

Replies: 2