Business Community > Wireless > EAP670 broadcasts no internet
< Wireless

EAP670 broadcasts no internet

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

EAP670 broadcasts no internet

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
EAP670 broadcasts no internet
EAP670 broadcasts no internet
2023-08-23 23:15:28

We just got our new Omada hardware in this week at the Church and I went to do setup today. I got the ISP modem corrected to the ER7206 and then to the TL-SG2218P and on that I have two EAP670s (added the second one just to eliminate possible bad hardware) and an OC300 controller. 

 

The computer plugged into the switch has internet and the SSID broadcasts and allows connections that show up on the controller page but no internet is available. I've tried protected and open networks to try and eliminate variables.

  0      
 
  0      
 
#1
Options
1 Reply
Re:EAP670 broadcasts no internet
2023-08-24 07:32:49

Hello @ClydeCoG，

 

Please use your phone connect or laptop to connect to the EAP’s Wi-Fi. If you can not find the WiFi or can not remember the password, you may reset the EAP and set it up again.

How to reset: please press the reset button on the EAP for 4 seconds and make sure the LED light changes, EAP's WiFi name will back to the default one tplink_5G and without a password.

Now use the phone to connect to the default WiFi and if you can see the error message “Obtain IP address fails”, or the phone can connect it but the IP address is 169.254.x.x. It is because the connection between the router and EAP fails. Please check the physical connection from the router to the EAP. If you are not sure, please use a PC to replace the EAP, connecting with the same Ethernet port and cable to check the PC can get internet or not.
 
If you can connect to the EAP’s Wi-Fi but no internet, please check the IP address on the phone or PC.
How to find IP address of Android smartphone/iPhone/iPad

 

If you can get a valid IP address, please do the Ping test on the PC, we need to Ping the router’s LAN IP, ping the 8.8.8.8 to check the connectivity.
Here is the instruction of the Ping test.

Best Regards! >> Omada EAP Firmware Trial Available Here << >> Get the Latest Omada SDN Controller Releases Here << *Try filtering posts on each forum by Label of [Early Access]*
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 813

Replies: 1

About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.