opnsense freeradius omada controller

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

opnsense freeradius omada controller

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

manustar

2024-08-13 22:30:41 - last edited 2024-08-14 01:17:36

Posts: 4

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2024-08-13

opnsense freeradius omada controller

2024-08-13 22:30:41 - last edited 2024-08-14 01:17:36

Hi, I'm configuring the radius (freeradius on opnsense), I set the radius profile on the omada oc200 controller with ip 10.0.0.254 port 1812 and 1813 for accounting, I activated authentication with the created profile, but if I put a PC it asks me user and password, however the APs (I entered the IPs among the radius clients) do not authenticate and go offline on the port where the radius is active, I also tried MAC authentication but from the radius logs I do not receive any authentication requests from that ap.

5 Reply

Vincent-TP

2024-08-14 06:54:54

Posts: 4339

Helpful: 427

Solutions: 1421

Stories: 0

Registered: 2024-06-22

Re:opnsense freeradius omada controller

2024-08-14 06:54:54

Hi @manustar

You may refer to this troubleshooting guide:

Troubleshooting for RADIUS Authentication Failure

Wish you a happy life and smooth network usage! >Omada US Enterprise Beta Program Launch< >Get the Latest Omada SDN Controller Releases Here< >Experience the Latest Omada EAP Firmware<

manustar

LV1

2024-08-14 11:36:23

Posts: 4

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2024-08-13

Re:opnsense freeradius omada controller

2024-08-14 11:36:23

hi @Vincent-TP

the problem is not the authentication itself, but on freeradius I really don't see the request coming when an eap610 ap is connected to the port, but if I connect a PC to the same port (same configuration), I see the request on freeradius and by entering the credentials works