CPE220 to service two locations in opposite directions
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Can one CPE serving as AP operate multi directional? If no, Can i split the signal to two CPE AP's back to back to serve oposite direction clients?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Check the datasheet for typical application of the CPEs - here.
You can use them in poin-to-point or point-to-multi point scenario.
CPE220 has built-in 12dBi 2x2 dual-polarized directional antenna - beam width: 60° (H-Plane) / 30° (E-Plane)
You may also watch this video for building a point-to-point connection.
- Copy Link
- Report Inappropriate Content
Check the datasheet for typical application of the CPEs - here.
You can use them in poin-to-point or point-to-multi point scenario.
CPE220 has built-in 12dBi 2x2 dual-polarized directional antenna - beam width: 60° (H-Plane) / 30° (E-Plane)
You may also watch this video for building a point-to-point connection.
- Copy Link
- Report Inappropriate Content
I currently have a point to point in place and understand the 60deg
I need to feed another building 180deg in the opposite direction
Do I do a separate point to point and split the router feed!
Are there other ways?
- Copy Link
- Report Inappropriate Content
Hi @Wldcat44
Do I do a separate point to point and split the router feed!
>>>This would be the best way.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 621
Replies: 3
Voters 0
No one has voted for it yet.