CPE510 + n750(TL-WDR4300)

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

CPE510 + n750(TL-WDR4300)

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
CPE510 + n750(TL-WDR4300)
CPE510 + n750(TL-WDR4300)
2015-09-16 12:35:30
Model :

Hardware Version : Not Clear

Firmware Version :

ISP :

I bought the CPE510 to connect to a friends Routers (Distance of 300mts) for gaming. I was wondering if I ran it through my N750 what settings I would need to use to get the Internet connection shared onto the 2.4Ghz network the router transmits or if it is even possible?
  0      
  0      
#1
Options
1 Reply
Re:CPE510 + n750(TL-WDR4300)
2015-09-16 13:49:54
1. Configure your CPE510 to Client mode with DHCP disable and mount it to face the direction of where your friend is.
2. Wire connect the LAN port of CPE510 to the WAN of 4300 and then setup the router to AP mode. There is the link below.
http://www.tplink.com/en/faq-417.html

Noticed:
1) Make sure that the CPE510 can get a good signal from your friend's router in the distance of 300m.
2) Since the CPE510 is a 5G product, the root router should be working on 5GHz frequency as well.
  0  
  0  
#2
Options

Information

Helpful: 0

Views: 296

Replies: 1

Related Articles