Can the Ethernet port be used as an outlet
Hi there. I want to send WiFi from a TP-Link EAP225-Outdoor Dual Band Wireless Indoor / Outdoor Access Point to a TP-LINK EAP673-EXTENDER Ax5400 then use the Ethernet as an outlet to a 8 port switch.
is that possible with the extender?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi @Steve2285
Yes.
To be sure, the topology would be like as below:
Internet source---Wired---EAP225-Outdoor)))wireless(((EAP673-extender---wired---switch.
Side note: if you haven't get any device, I would recommend replacing EAP225-outdoor with a wifi6 outdoor EAP. such as EAP610-outdoor.
- Copy Link
- Report Inappropriate Content
Hi @Steve2285
Yes.
To be sure, the topology would be like as below:
Internet source---Wired---EAP225-Outdoor)))wireless(((EAP673-extender---wired---switch.
Side note: if you haven't get any device, I would recommend replacing EAP225-outdoor with a wifi6 outdoor EAP. such as EAP610-outdoor.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Hi @Steve2285
EAP610 ceiling mount indoor or EAP610-outdoor?
If outdoor, yes, it's easy, you can configure the second EAP610-outdoor as repeater mode:
How to configure Omada EAP in Repeater mode
If the indoor unit, you will need a controller to build a mesh for the two EAP units.
How to Build a Mesh Network via Omada EAP in Controller Mode
Steve2285 wrote
- Copy Link
- Report Inappropriate Content
hi Vincent. Sorry but that link was about wireless repeater only. I couldnt find what I'm trying to do.
I'll explain what I'm trying to do. I want to use one of the outdoor AP's to send WiFi 200 meters to another device which will then plug into a PoE switch. Offthe PoE switch will be 4 security cameras. I don't want the EAP as a repeater I need to be able to plug it into the PoE switch. Is that possible?
- Copy Link
- Report Inappropriate Content
Hi @Steve2285
Yes. It's possible with two outdoor EAP units.
However, based on your scenario, I recommend EAP outdoor bridge KIT products instead.
They have directional antennas, which should provide a more stable wireless connection.
Below for your refernece:
How to establish a point-to-point connection with EAP-Bridge
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 176
Replies: 5
Voters 0
No one has voted for it yet.