C560WS and CPE710 v1.0
My C560ws is currently being detected as a Station on my CPE710 v1.0. I've attached an image for reference.
Could you please let me know if this is the expected or correct behavior?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hi @Nesswill
In that case, I recommend ignoring this issue as it doesn’t affect functionality at all. Meanwhile, I’ll report this behavior to our relevant team.
Thank you very much for your feedback.
Nesswill wrote
Vincent-TP wrote
Hi @Nesswill
Thanks for the reply.
I suggest you install and configure the other CPE first, then observe the behavior. This camera's connection distance might be similar to P2P, causing it to be identified as a station.
Hi the other CPE710 is all configured and setup, currently its a backup connection, P2P is disabled on my network (in router Draytek 3910 - CSM >> APP Enforcement Profile)
Dave.
- Copy Link
- Report Inappropriate Content
Hi @Nesswill
Thanks for posting here. This is not correct behavior..
How many CPE710 do you have? Is there another CPE station connecting to this CPE710?
Please disconnect the camera, reconnect, and see if the situation persists.
- Copy Link
- Report Inappropriate Content
Device Model:
CPE710 v1.0
Firmware Version:
2.3.0 Build 20211216 Rel. 41372 (0000)
Thanks for posting here. This is not correct behavior..
OK
How many CPE710 do you have?
2 but the second CPE710 is off and has not been turned on since installing the camera.
Is there another CPE station connecting to this CPE710?
No not currently but at some point in the future it will, see above.
Please disconnect the camera, reconnect, and see if the situation persists.
Done, rebooted and connected to a different WAP and 0 Stations on the CPE710, but if it reconnects to the CPE710 it reappears as a Station.
Thanks Dave.
- Copy Link
- Report Inappropriate Content
Hi @Nesswill
Thanks for the reply.
I suggest you install and configure the other CPE first, then observe the behavior. This camera's connection distance might be similar to P2P, causing it to be identified as a station.
- Copy Link
- Report Inappropriate Content
Vincent-TP wrote
Hi @Nesswill
Thanks for the reply.
I suggest you install and configure the other CPE first, then observe the behavior. This camera's connection distance might be similar to P2P, causing it to be identified as a station.
Hi the other CPE710 is all configured and setup, currently its a backup connection, P2P is disabled on my network (in router Draytek 3910 - CSM >> APP Enforcement Profile)
Dave.
- Copy Link
- Report Inappropriate Content
Hi @Nesswill
In that case, I recommend ignoring this issue as it doesn’t affect functionality at all. Meanwhile, I’ll report this behavior to our relevant team.
Thank you very much for your feedback.
Nesswill wrote
Vincent-TP wrote
Hi @Nesswill
Thanks for the reply.
I suggest you install and configure the other CPE first, then observe the behavior. This camera's connection distance might be similar to P2P, causing it to be identified as a station.
Hi the other CPE710 is all configured and setup, currently its a backup connection, P2P is disabled on my network (in router Draytek 3910 - CSM >> APP Enforcement Profile)
Dave.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 227
Replies: 5
Voters 0
No one has voted for it yet.