SOHO Switches
Hi, We have four TL-SG1016PE switches that won't boot. When I connect the power I can hear the Fan and the power led becomes green. But when I connect a device to a port the port led will stay off and
Network ConnectivityConfiguration
2Helpful
152Views
I cannot find a way to configure my Switch TL-SG108E using the TP-Link interface. All my devices connected to the switch do work, however with only 100mbs, instead of 1GB. So i wanted to check the set
Configuration
By
MemoriesLP
· Latest post 2025-02-19 20:23:06
by D-C
3Helpful
378Views
I'm trying to learn quite a bit about VLANs and still my head is spinning ... I have a really small network consisting of a Huawei LTE-Internet router (very basic network konfiguration) that does WLAN
VLAN & Multi-NetworksConfiguration
By
smallfreak
· Latest post 2025-02-15 10:26:39
by smallfreak
2Helpful
167Views
looking to upgrade our office switches with some TP-Link models. as i understand, all my models below support MDI/MDIx which should mean i am able to connect a straight thru ethernet (not crossover) f
ConfigurationNetwork Connectivity
2Helpful
470Views
Hi, I am looking to purchase the Deco X50 3 pack and setup ethernet backhaul for my house via the ethernet switch. I can't seem to find any specification details on whether the LS1005G is compatible f
Network ConnectivityConfigurationVLAN & Multi-NetworksMESH Network
2Helpful
386Views
Hi! Please help, I'm out of ideas. I have a FortiGate UTM with VLANs on ports 1,2 (LAG) and I want to connect Access Points primarily through a TL-SG108PE switch. I connect a computer for testing and
VLAN & Multi-NetworksConfiguration
1Helpful
531Views
Hello, I need some help as I am confused. Been watching videos and reading on vlan but cant seem to make it work. I have 1 Router (No Vlan Settings) 2 x TL-SG108E and many devices.. Switch 1 is connec
VLAN & Multi-NetworksConfiguration
4Helpful
526Views
Hello, I have TL-SG105E switch and I have the following problem. I want to separate my network devices so that specific devices can see only specific devices. The situation is like this: The switch ha
ConfigurationVLAN & Multi-NetworksNetwork ConnectivityPort isolation
By
Programmer001
· Latest post 2024-10-12 01:52:13
by Clive_A
1Helpful
252Views
Hi, I'm already struggling couple of days with the topic so i need your help :) Lets start with the topology description ROUTER 1 -> ROUTER2 (access point) -> ROUTER3 (access point) -> SG108PE -> EAP1
ConfigurationPoENetwork ConnectivityFirmware Update
1Helpful
414Views
Hello, I would like to set up access control via mac addresses of the connected devices. I only want to allow devices into my lan whose mac I have entered in the switch, which are known. The whole thi
Configuration
1Helpful
304Views