Gateways
I'm getting the following error in software controller 6.1.0.19 trying to configure my gateway (ER707-m2) with port forwarding: "Cannot create a port forwarding rule with the same Interface, Source Po
RoutingNATControllerFirewall
3Helpful
107Views
I have a ER605 gateway with a OC300 controller and multiple EAPs. I have a 1gig down/up fiber connection with supplied modem from our Internet provider. I don't seem to have any issues with my compute
RoutingNetwork ConnectivityFirewallDNS
0Helpful
49Views
Short version: I set up a bunch of time-based URL filtering rules, and I get very mixed results. Sometimes on the same computer, Firefox will be blocked from loading a blocked website, but Safari will
FirewallRoutingurl filtering
1Helpful
313Views
I am trying to set things up so that traffic (UDP audio streams) can pass through specific ports on a ER605 (in standalone mode, we do not use Omada Controllers here), via port-forwarding, but only if
Firewallwhitelisting
By
aaronread1
· Latest post a week ago
by aaronread1
0Helpful
161Views
I've read a handful of threads about the IPv6 "firewall" (likely misreferenced as an ACL). I saw from searching the forums in a somewhat recent thread from 2025 there is a "deny all by default" ACL fo
IPv6FirewallACL
By
therealbob
· Latest post 2 weeks ago
by Hank21
0Helpful
141Views
Hello I want to ask about "Block ping from WAN" function in FireWall section (ER605 HW v2.20 latest firmware 2.3.3). The box is checked and I can't ping my WAN and that's OK. When uncheck box and save
Firewall
By
KajtekKajtek
· Latest post 2026-01-25 16:43:18
by KajtekKajtek
0Helpful
478Views
Sorry, but just a bit confused ... as there seem to be 2 settings for the same DNS info - not quite sure how they work together :(. I'm hoping someone can clarify. Thanks in advance! For the DNS confi
DNSFirewall
0Helpful
238Views
Hello everyone, I have a problem. I replaced my (Germany) Telekom Speedport 4 with a Fiber Modem 2b and connected directly via PPPoE using the ER8411. Everything worked perfectly. However, since then
WAN SetupNATFirewallDNSER8411
0Helpful
191Views
Hi, in standalone mode Firewall-mac filtering-allow only listed below and deny the rest dont work. I have 30+ mac adresses in list, but every Not listed device can connect to whole network, successful
Network ConnectivityFirewallFirmware Update
1Helpful
1017Views
I have inherited a TP Link Omada setup and am trying to setup segregation between VLANs. I've started by creating firewall rules to deny traffic between the different VLANs, however, I need to be able
FirewallVLAN & Multi-Networks
By
theradioguy
· Latest post 2025-12-21 11:30:12
by invadia
5Helpful
3575Views
The ER706W hardware version is actually v1.20. I have a question on isolating networks with the latest firmware (1.2.0 Build 20250428). I do not have the latest firmware installed because of a boot pr
VLAN & Multi-NetworksFirewall
1Helpful
615Views
My setup is I have fortigate firewall interconnected to ER7412-M2 (LAN of fortiate to WAN of ER7412) I configured routing on both sides and firewall policy on fortigate to have communication to local
NATFirewallACLRouting
2Helpful
436Views