Gateways
Hi, I am using a TP-Link Omada ER605 v2.20 configured via the cloud. I have configured WAN1 and WAN2 for failover, where WAN1 is supposed to be the primary connection and WAN2 acts as a backup in case
WAN SetupVLAN & Multi-NetworksTopologyNetwork Connectivity
By
aksport
· Latest post 19 hours ago
by Gabriel-TP
0Helpful
57Views
Hi Guys Been Omada user for many years so familier with the usual VLN/LAN/AP/SWITCH setup.... however had a play with a Gateway for the first time - having used a variety of UTM devices with Omada pre
VLAN & Multi-NetworksTopology
1Helpful
170Views
Hi Guys Been using UNTANGLE, Watchguard, Astaro and OpnSense for years, and found the alure of extending an Omada setup to include a gateway too much to ignore. Bought the ER7412-M2 - but cant see how
RoutingNetwork ConnectivityTopology
1Helpful
397Views
Hi Everyone - Looking for some layout advice here. Hardware Specs - Spectrum cable modem 500/25. Is not a router as well. ER707 VPN Gateway with 2 ISP lines in ports 2&3 with fail-over activated. Arch
Network ConnectivityControllerTopology
0Helpful
287Views
I can see the wired clients on the LAN interfaces, but the uplink port information never appears. LLDP is enabled, but neither the latest stable firmware from 10/25 nor the 1.4 beta shows which ports
Topology
0Helpful
299Views
Hello, I have a fairly basic setup with -- Gateway ER605 v1.0 connected to internet -- Wireless access point EAP660 HD(US) v1.0 for wireless access -- I use Software based omada controlled to administ
VLAN & Multi-NetworksDHCP ServiceTopology
1Helpful
312Views