Home

Forums

Stories

Knowledge Base

Business Community > WiFi > Howto: Install TP-Link EAP Controller 3.0.5 on a Raspberry Pi

< WiFi

Howto: Install TP-Link EAP Controller 3.0.5 on a Raspberry Pi

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Howto: Install TP-Link EAP Controller 3.0.5 on a Raspberry Pi

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

jobhh

2019-01-07 14:44:23 - last edited 2019-01-07 14:45:59

Posts: 3

Helpful: 2

Solutions: 0

Stories: 0

Registered: 2018-12-28

Howto: Install TP-Link EAP Controller 3.0.5 on a Raspberry Pi

2019-01-07 14:44:23 - last edited 2019-01-07 14:45:59

I've posted this some time back in the "Omada Controller 3.0.2 for Linux (including new tpeap v1.4)" thread, but figured maybe a seperate topic would be better.

We were deciding between buying the OC200 or running the controller software on a Raspberry Pi and decided to do some tinkering. We're running the official 3.0.5 binaries from TP-Link. However, because TP-Link uses some binaries compiled for x86 we're using Java and MongoDB versions provided by Debian/Raspbian compiled for the ARMv8 platform.

Howto: Installing TP-Link EAP Controller 3.0.5 on a Raspberry Pi

If anyone has questions, I'm not very often at this forum, but will answer when I can :)

3 Reply

7eleven

LV2

2019-01-09 09:52:51

Posts: 80

Helpful: 10

Solutions: 2

Stories: 0

Registered: 2018-07-24

Re:Howto: Install TP-Link EAP Controller 3.0.5 on a Raspberry Pi

2019-01-09 09:52:51

Hi jobnn,

The TP-Link said the minimum RAM requirement of Omada Controller is about 2G, I think the RAM of Raspberry Pi is just 1G, do you think if it may affect the performance of Controller?