Deco M4 as AP - an CPE510 as client cannot see the AP

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Deco M4 as AP - an CPE510 as client cannot see the AP

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Kenny_PDY

LV1

2020-07-18 16:17:53 - last edited 2020-07-20 03:55:43

Posts: 2

Helpful: 0

Solutions: 1

Stories: 0

Registered: 2020-07-18

Deco M4 as AP - an CPE510 as client cannot see the AP

2020-07-18 16:17:53 - last edited 2020-07-20 03:55:43

Model: Deco M4

Hardware Version:

Firmware Version: 1.4

I have an operational two Deco M4 mesh working. Would like to connect a CCTV camera to this network using CPE510. Setup the CPE as client mode and let it scan for Deco SSID within the same room but it cannot found Deco. The CPE discover nearby SSID fine. Is it possible that there were too close? Or Deco and CPE510 operate on different 5GHz channels? Both Deco and CPE are at the current firmware. The CPE HW is 3.2

Regards
Kanok

1 Accepted Solution

Kenny_PDY

LV1

2020-07-20 03:55:36 - last edited 2020-07-20 03:56:51

Posts: 2

Helpful: 0

Solutions: 1

Stories: 0

Registered: 2020-07-18

Re:Deco M4 as AP - an CPE510 as client cannot see the AP-Solution

2020-07-20 03:55:36 - last edited 2020-07-20 03:56:51

@Kenny_PDY Found out that when select Thaland as the region at CPE, the CPE disable band 1 while Deco uses channel 36 (band 1) on 5G band with no option to select the region. Had to find country region that enable band 1 with 20/40 MHz bandwidth on the CPE. Now the connection is made and stable.

Problem solved.

Information

Helpful: 0

Replies: 1

Deco M4 as AP - an CPE510 as client cannot see the AP

Deco M4 as AP - an CPE510 as client cannot see the AP

Information

Voters 0

Tags