Feature Request (Extenders)
0
VotesI recently added a TL-WPA8631P Extender to my TL-PA9033P powerline network. I used WPS to configure the WiFi settings to match my Plusnet Hub Two router. This allowed devices on 2.4GHz to connect to e
Device Name
73Views
12
VotesSo I just bought an RE300 dual band mesh extender to replace my old N300. Unfortunately despite checking my C7 router supported one mesh it turned out I needed v5 hardware & mine was v4 :( No problem,
EasyMeshOnemesh
8765Views
0
VotesDear TP-Link Team, I’m writing to request the addition of WPA3 support for the RE650 V2 EU range extender. As a long-time user of TP-Link products, I appreciate your commitment to performance and secu
By
Ikramuddin20
92Views
1
VotesIt would be very nice if RE550 supported EasyMesh Network via Ethernet Backhaul. Is it only a firmware implementation? Or this hardware is not capable?
EasyMesh Ethernet BackhaulEasyMesh
By
jvicient
· Latest post 2 weeks ago
by Andrsouzaaa
428Views
30
VotesFuture ConsiderationDaisy chain OneMesh WiFi extender
Hello all, I have a OneMesh router with two OneMesh extenders set up in my home. The problem is that one of the extenders is too far from the main router and I need to daisy chain it with an extender
OneMesh
16563Views
0
VotesGood afternoon, Currently using Archer AX53 connected with easymesh to TL-WPA7617, but its currently using this mode via wireless as shown on the internal page. Current website info says full support
EasyMesh Ethernet Backhaul
By
Fagulhas
· Latest post 3 weeks ago
by jhostinbecerra1
198Views
1
VotesHello, I purchased the RE600X a few years ago and have been very satisfied with it. I am currently using two units in my setup—not as extenders, but as access points, since my apartment is fully wired
VLAN
By
ceekay2k
862Views
6
VotesCurrently, we only have options for scheduled power off in hours for RE550, and we can only choose by "hours". Can we have scheduled power off in "minutes"? Example, from 3:00am to 3:01am. Main purpos
By
Kartronics12
· Latest post 2025-09-17 00:36:47
by FerdinandBenes
2789Views
2
VotesI saw the us version of that model just get ethernet backhaul with software update, we want to get it too.
EasyMesh Ethernet BackhaulEasyMeshOnemeshfirmware update
2675Views
0
VotesHello, I'm following this thread to get updates of Ethernet Backhaul support for range extenders. So far you've published 2 new firmware for RE700X(US)_V2 and RE700X(EU)_V1 thank you for those. I'm wa
EasyMeshOnemeshEasyMesh Ethernet Backhaul
By
SS_Rock
2409Views