Access Points
The Access Point products are mainly designed to establish a wireless network, and, with multiple working modes, you can also expand your existing wireless network or provide internet access to your wired only devices. In this section you can say hello to other members, ask, answer or discuss technical topics regarding Access Points.
Access Points
PLEASE IGNORE THE MODEL SELECTION - I HAD TO CHOOSE ONE AND MY WIRELESS AP WAS NOT ON THE LIST I've just installed a TL-WA1201 wireless AP into my home network and wish to use it's multi-ssid feature
Highlighted Thread
32Helpful
13517Views
I bought your TL-WA1201 for multi-SSID, but it is so unreliable that it is useless. On your support chat they told me it's a known issue, but can't give me a fix date and cannot offer an alternative (
Highlighted Thread
By
Wizz
· Latest post 2022-11-01 03:16:34 by
Solla-topee
10Helpful
3996Views
Hi I have two TL-WA1201 APs. One is in an area where relatively few devices connect and is abolutely fine. The other is in an area where eaily 25 plus devices connect (laptops/ipads/Echos and Particle
Highlighted Thread
18Helpful
6635Views
I have the above AP. I can set-up ssid-s with different vlan id-s and it works (except that remote access is not working in multi-ssid mode, regardless if vlan mode is enabled or not - there is an oth
3Helpful
2125Views
0Helpful
85Views
I have about 20 of these devices across multiple sites. We recently replaced our Hitron CGNV4 routers for Hitron Chita routers. Before the change, all access points worked fine with no problems. All a
2Helpful
467Views
Dear TP link Support team, Please your kind support , I have AP TL-WA801ND(EU) I have been using it since almost 3 years , recently tried to access the web interface but I coudnt , I did pin reset two
By
Rami-Cloud
· Latest post Friday by
APPPP
0Helpful
46Views
Why the HELL TL-WA1201 does not support mac filtering whitelist? Blacklist option is bullsh*t. We need to only allow certain devices. Can this be fixed by a firmware upgrade? Or should we throw the us
0Helpful
19Views
Hi there, I have got a lot of TL-WA1201 v2 and now I've bought two new TL-WA1201 v3 access points. How can I configure a wireless MAC filtering in v3? I cannot find this option in the menu. In v2, it
1Helpful
125Views
Im facing an issue whereby each time i connect the 1201 ap to a cisco switch, the port shuts down into err disabled state. The AP only starts working when i issue a no keepalive on the 2960 switch but
By
Hasma
0Helpful
26Views