Business Community > WiFi > EAP 255 Wall POE Issue
< WiFi

EAP 255 Wall POE Issue

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

EAP 255 Wall POE Issue

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
EAP 255 Wall POE Issue
EAP 255 Wall POE Issue
2020-08-03 01:40:53
Model: AP200  
Hardware Version:
Firmware Version:

Hi,

 

I just bought EAP 255 Wall and it's working fine by using POE but when I'm using the out Ethernet POE Port it's not providing any power.

  0      
 
  0      
 
#1
Options
3 Reply
Re:EAP 255 Wall POE Issue
2020-08-03 01:46:41
I'm using TRENDnet TI-PG541 Switch.Tried also with Cisco SG110-24 and it's not working
  0  
  0  
#2
Options
Re:EAP 255 Wall POE Issue
2020-08-03 13:26:51

@Hussam_k, did you check whether PoE setting in the web UI or the controller is disabled/enabled for this EAP?

༺ 0100 1101 0010 10ཏ1 0010 0110 1010 1110 ༻
  0  
  0  
#4
Options
Re:EAP 255 Wall POE Issue
2020-08-04 02:25:26

Hi Hussam_k 

 

To supply power to the connected device on the out Ethernet PoE port, please ensure the PoE Out option is enabled (disabled by default).

 

 

>> Omada EAP Firmware Trial Available Here << *Try filtering posts on each forum by Label of [Early Access]*
  0  
  0  
#5
Options

Information

Helpful: 0

Views: 590

Replies: 3

About Us
Press
Copyright © TP-LINK CORPORATION PTE. LTD. All rights reserved.