Home

Forums

Stories

Knowledge Base

Business Community > Controllers > gateway and switch not showing in dashboard

< Controllers

gateway and switch not showing in dashboard

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

gateway and switch not showing in dashboard

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

chan11

2020-08-30 01:06:51 - last edited 2020-12-31 09:13:08

Posts: 1

Helpful: 0

Solutions: 0

Stories: 0

Registered: 2020-08-27

gateway and switch not showing in dashboard

2020-08-30 01:06:51 - last edited 2020-12-31 09:13:08

Model: OC200

Hardware Version:

Firmware Version:

i have a problem that the omada controller couldn't recognize any gateway or switches

My currrent setup is ISP --> tplink TL-R600VPN --> tplink T1600G-28PS switch --> 7 EAPs + OC200

every things works fine, i could access to internet without any problems but i was just wondering if there is a way to make to OC200 recognize my switch and routers.

1 Accepted Solution

Fae

2020-08-30 11:47:05 - last edited 2020-09-08 01:17:11

Posts: 3613

Helpful: 1357

Solutions: 474

Stories: 0

Registered: 2020-06-30

Re:gateway and switch not showing in dashboard-Solution

2020-08-30 11:47:05 - last edited 2020-09-08 01:17:11

Dear @chan11,

At present, only some certain devices support Omada SDN platform.

The TL-R600VPN doesn't support Omada SDN controller for the moment, while T1600-28PS 3.0 will release a firmware to support SDN controller in the near future, you may check more info from this post.

>> Omada EAP Firmware Trial Available Here << *Try filtering posts on each forum by Label of [Early Access]*

Recommended Solution

1 Reply

Fae

2020-08-30 11:47:05 - last edited 2020-09-08 01:17:11

Posts: 3613

Helpful: 1357

Solutions: 474

Stories: 0

Registered: 2020-06-30

Re:gateway and switch not showing in dashboard-Solution

2020-08-30 11:47:05 - last edited 2020-09-08 01:17:11

Dear @chan11,

At present, only some certain devices support Omada SDN platform.

The TL-R600VPN doesn't support Omada SDN controller for the moment, while T1600-28PS 3.0 will release a firmware to support SDN controller in the near future, you may check more info from this post.

>> Omada EAP Firmware Trial Available Here << *Try filtering posts on each forum by Label of [Early Access]*

gateway and switch not showing in dashboard

gateway and switch not showing in dashboard

Information

Voters 0

Tags