Business Community > Routers > How to limit the bandwidth or rate using mac address
< Routers

How to limit the bandwidth or rate using mac address

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

How to limit the bandwidth or rate using mac address

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
How to limit the bandwidth or rate using mac address
How to limit the bandwidth or rate using mac address
2020-10-16 21:00:05 - last edited 2021-04-18 10:49:06
Model: TL-R600VPN  
Hardware Version: V4
Firmware Version: TL-R600VPN(UN)_v4_20190227

Hey guys,

How can I limit the bandwidth / rate using mac address?

  0      
 
  0      
 
#1
Options
2 Reply
Re:How to limit the bandwidth or rate using mac address
2020-10-19 10:38:43 - last edited 2021-04-18 10:49:06

Dear @Heujenthro,

 

How can I limit the bandwidth / rate using mac address?

 

The TL-R600VPN router only supports bandwidth control based on IP address, for which you may refer to the guide below.

https://www.tp-link.com/support/faq/2152/

>> Omada EAP Firmware Trial Available Here << *Try filtering posts on each forum by Label of [Early Access]*
  0  
  0  
#2
Options
Re:How to limit the bandwidth or rate using mac address
2020-10-19 15:00:42 - last edited 2021-04-18 10:49:06
Okay thanks for the response.
  0  
  0  
#3
Options

Information

Helpful: 0

Views: 1108

Replies: 2

About Us
Press
Copyright © TP-Link Corporation Limited. All rights reserved.