eap225 lost channels

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

eap225 lost channels

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
eap225 lost channels
eap225 lost channels
2020-11-12 05:46:24 - last edited 2020-11-16 01:23:21
Model: EAP225-Outdoor  
Hardware Version: V1
Firmware Version: 1.20.0 Build 20200422 Rel. 70543

someone help me please 

two of my outdoor 225's were slower than normal so i upgraded firmware. after the update both are showing as connected in the controller but both are w/o channels nor showing down load or upload speeds. what am i missing. 

  0      
  0      
#1
Options
1 Accepted Solution
Re:eap225 lost channels-Solution
2020-11-12 11:51:25 - last edited 2020-11-16 01:23:21

Dear @groovines,

 

two of my outdoor 225's were slower than normal so i upgraded firmware. after the update both are showing as connected in the controller but both are w/o channels nor showing down load or upload speeds. what am i missing. 

 

 

Please pay attention to the red notes below the new firmware before you upgrade it. 

 

 

The firmware Build 20200422 only compatible with Omada Controller V4.1.5 or above, so please upgrade Omada Controller as well.

It's highly recommended to read the Upgrade Guide before you upgrade the Omada Controller.

>> Omada EAP Firmware Trial Available Here << *Try filtering posts on each forum by Label of [Early Access]*
Recommended Solution
  0  
  0  
#2
Options
8 Reply
Re:eap225 lost channels-Solution
2020-11-12 11:51:25 - last edited 2020-11-16 01:23:21

Dear @groovines,

 

two of my outdoor 225's were slower than normal so i upgraded firmware. after the update both are showing as connected in the controller but both are w/o channels nor showing down load or upload speeds. what am i missing. 

 

 

Please pay attention to the red notes below the new firmware before you upgrade it. 

 

 

The firmware Build 20200422 only compatible with Omada Controller V4.1.5 or above, so please upgrade Omada Controller as well.

It's highly recommended to read the Upgrade Guide before you upgrade the Omada Controller.

>> Omada EAP Firmware Trial Available Here << *Try filtering posts on each forum by Label of [Early Access]*
Recommended Solution
  0  
  0  
#2
Options
Re:eap225 lost channels
2020-11-12 13:28:15

Welcome @groovines,

 

Are you running the Omada SW?  Or do you have an OC-200?

 

As Fae said, you'll need to use the new/current version of the Omada/SDN software to be compatible with the updated EAP225-OD drivers.

 

-Jonathan

  0  
  0  
#3
Options
Re:eap225 lost channels
2020-11-12 21:19:58

@Fae thanks!  I'll try updating server software tonight . the only fear is that if something goeas wrong  my indoor EAP255 that is currently working just fine will croak and leave me w/o any wifi . afrer all its' 2020 so what elese can possibly happen:-)

 

  0  
  0  
#4
Options
Re:eap225 lost channels
2020-11-12 21:23:25

@JSchnee21 

Hi Johnantan, thanks for response,. I'm just running web based server . My AP's are plugged to some Netware POE's 

i'm going to run the server software update tonigth 

 

  0  
  0  
#5
Options
Re:eap225 lost channels
2020-11-13 13:45:12

Hi @groovines,

 

Sounds good.  A new version of Omada is out both for standalone SW and OC-200.  But be advised, it's not a seemless upgrade from Omada to the new SDN.  You'll need to reconfigure your setup under the new SDN software.

 

-Jonathan

  0  
  0  
#6
Options
Re:eap225 lost channels
2020-11-13 16:43:41

@JSchnee21 

thanks so much Jonathan, I have not done the upgrade yet . Most of Florida Keys lost internet yesterday . 

regarding reconfiguration; Do you know if there are any specific instructions or videos available that i could read/watch before i mess something up 

really appreciate your help 

 

  0  
  0  
#7
Options
Re:eap225 lost channels
2020-11-15 21:03:34

@groovines 

i upgraded the controller to 4.2.4  and both outdoor AP's are working now. however indoor 225 says it's incompatible with the server. i did check the compatibility list and it should be fine . any ideas? 

also i end up with two unsecured wifi networks . (2.4 and 5) wod do i hide them ? 

  0  
  0  
#8
Options
Re:eap225 lost channels
2020-11-15 22:55:53

@groovines 

never mind ! my fdirst firmware upgrade on 225 indoor did not take and this caused both issues. All is good now. THank you guys for help Very very much 

 

  2  
  2  
#9
Options