Omada Controller Client List not Refreshing

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
12

Omada Controller Client List not Refreshing

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
15 Reply
Re:Omada Controller Client List not Refreshing
2020-11-22 17:45:17

@rtadams89 

 

But you wasn't asking about devices that was connected, you asked about devices that are not.

 

If you still have your windows device, i'd like you to try the same process but without importing your configuration - just to rule it out.

 

Not that i can help here with the issue, just suggesting things i would try.

  0  
  0  
#12
Options
Re:Omada Controller Client List not Refreshing
2021-11-07 20:33:18

@rtadams89 it has almost been a year. Did you see it being resolved for you or still the same? I am having the same issue and I am on the latest 4.4.6 on OC200 hardware. I keep seeing disconnected clients or clients saying with the wrong ip after a reboot a gated way and something else played dhcp server. That something else long gone. I have ER7206 router and TL-SG2008P (v1.0) switch and a couple of Eap615-Wall. Cannot upgrade the switch from an armada controller. But the list of clients seems stale. Even when force reconnect from the UI

  0  
  0  
#13
Options
Re:Omada Controller Client List not Refreshing
2022-04-20 13:04:37

  @rtadams89 

20/04/22, oc200 5.1.7, still same issue....

  0  
  0  
#14
Options
Re:Omada Controller Client List not Refreshing
2022-05-11 20:10:18 - last edited 2022-05-11 20:21:20

Cotchet wrote

  @rtadams89 

20/04/22, oc200 5.1.7, still same issue....

  @Cotchet I have the same issue, also running 5.1.7 with a single EAP-225 only at the moment as it is test system. Testing shows it takes 5 minutes to show client has disconnected. Do other models of AP have the same delay?

  0  
  0  
#15
Options
Re:Omada Controller Client List not Refreshing
2022-06-22 23:19:17 - last edited 2022-06-22 23:19:44

  @rtadams89 unfortunately I seem to be facing a related issue. I simply want to set a static IP for a device.

 

I go to Clients -> select the client -> config -> use fixed IP check and set

 

The client still shows as the old IP address and the refresh button isn't working. In addition, I went into the device's settings itself and made sure the IP address was manually set to the new IP and it is on the device, but on the TP link controller, it's still showing the old IP address.

 

I don't know what's going on, but not having a list of real IP address is concerning. This is a serious problem. I don't know what anything is actually assigned to.

  0  
  0  
#16
Options