Devices connected to 5 Ghz can't connect to devices connected to 2.4 Ghz
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.Devices connected to 5 Ghz can't connect to devices connected to 2.4 Ghz
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I realized that when I connect to 5Ghz I can't communicate to devices connected to 2.4Ghz.
Obviously they are in the same net and using ip given by DHCP.
I can connect to wired devices and devices using the same frequency.
How can I fix that?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
I updated firmware to 3.15.3 Build 180305 Rel.51282n.
Still remain the problem.
- Copy Link
- Report Inappropriate Content
Look at the following screenshot:
If these are checked - un-check them for both 2.4 & 5 GHz bands and click Save.
Then you'll be able to communicate between these devices.
- Copy Link
- Report Inappropriate Content
Nope, the options are unchecked...
- Copy Link
- Report Inappropriate Content
Try to hard reset the router and re-configure from scratch. After FW update it helps in most of the cases.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
What do you mean by sometimes can see them, sometimes can not ? When you see them how do you try to communicate with them ? What are those devices phones, computers ?
- Copy Link
- Report Inappropriate Content
my phone when connected to 5ghx can't ping (and access) for example wifi printer, or wifi plug that connect with 2.4ghz. Not always but most of the times.
- Copy Link
- Report Inappropriate Content
Obviously that's intermittent, but not persistent. When that happens what's the distance between your phone and the router, are you receiving a good wireless signal from your router on 5 GHz band ? Maybe they are too far from each other.
- Copy Link
- Report Inappropriate Content
@Ivaylo the signal is strong. The device is well connected to internet. It just don't see devices on the other band. But it connect well with wired devices (NAS, and others...)
- Copy Link
- Report Inappropriate Content
Since when you are experiencing this issue ? Even before upgrading the router's FW? Have you made any changes to your local network recently ?
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 2778
Replies: 19
Voters 0
No one has voted for it yet.