Business Community > Routers > TL - ER5120 Load Balancer Outbound IP
< Routers

TL - ER5120 Load Balancer Outbound IP

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

TL - ER5120 Load Balancer Outbound IP

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
TL - ER5120 Load Balancer Outbound IP
TL - ER5120 Load Balancer Outbound IP
2021-01-01 17:25:06 - last edited 2021-04-18 10:19:02
Model: TL-ER5120  
Hardware Version: V4
Firmware Version:

I have recently purchased TL ER 5120 Load Balancer

Connected 2 WAN successfully

 

Only one problem,

When I

 

a. Make Speed test

b. Ask what is my IP

 

It gives the number of  WAN 1 IP only

 

Why it gives WAN 1 IP only?

 

Or is it possible to change WAN 2 IP to be seen in What is my IP or speed test trials?

 

I tried Router, NAT or other options, but Maybe I was unsuccessfull

 

THANK YOU for answering

 

 

 

  0      
 
  0      
 
#1
Options
1 Reply
Re:TL - ER5120 Load Balancer Outbound IP
2021-01-03 15:06:41 - last edited 2021-04-18 10:19:02

@Invincible1980 

 

Have you enabled load balancing?  

 

When load balancing is enabled, the router will try balance load on the configured WANs. 

 

AFAIK, The behavior of the router is not known when the load balancing is disabled. If may try use only WAN1 and only when the load is high on WAN1 it will try to use WAN2. 

 

You can monitor the Traffic Statistics page to get an idea on how the traffic is being distributed. 

 

 

 

 

 

  0  
  0  
#2
Options

Information

Helpful: 0

Views: 368

Replies: 1

About Us
Press
Copyright © TP-Link Corporation Limited. All rights reserved.