Business Community > Controllers > Rate Limit does not work
< Controllers

Rate Limit does not work

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Rate Limit does not work

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Rate Limit does not work
Rate Limit does not work
2021-02-13 07:48:03
Model: OC200  
Hardware Version: V1
Firmware Version: 1.7.3 Build 20201119 Rel.63433

Hello,

I tried set Rate Limit on my Synology NAS, but no success. 

Is something working properly on this device?

Pavel

 

HW Controller: OC220 1.0 Gateway: ER707-M2 v1.20 Switch: SG2210XMP-M2 v1.0 AP: EAP773(EU) v1.0
  0      
 
  0      
 
#1
Options
2 Reply
Re:Rate Limit does not work
2021-02-13 08:28:50

Hello, 

I found a solution, Port Profile, set speed limit. Is it not possible to solve it elegantly via Device Config? Here the restriction only works for wifi clients.

 

HW Controller: OC220 1.0 Gateway: ER707-M2 v1.20 Switch: SG2210XMP-M2 v1.0 AP: EAP773(EU) v1.0
  0  
  0  
#2
Options
Re:Rate Limit does not work
2021-02-15 20:16:32

@PavelV 

 

Under SETTINGS  > TRANSMISSION > BANDWIDTH CONTROL you can set it in there for VLAN or IP Group

 

I have it set for VLAN at moment and it works perfectly.

  0  
  0  
#3
Options

Information

Helpful: 0

Views: 1173

Replies: 2

About Us
Press
Copyright © TP-Link Systems Inc. All rights reserved.