Bind Address for omada SDN software controller
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hello,
Is there a way to specify the IP address the Omada SDN Controller will bind to?
I have the SDN controller installed on a multi-nic Centos server, and it binds to all adresses by default.
I need to limit the binding to one specific IP address.
Regards,
Dear @mduchaine,
Go to Settings > Controller, configure Controller Hostname/IP under Access Config.
Note: the Controller Hostname/IP setting is added in Omada SDN v4.2.4, you may upgrade your controller for it.
https://www.tp-link.com/en/support/download/omada-software-controller/v4/#Controller_Software
Dear @Fae
Unfortunately it's not working. My linux box has 2 IP addresses: 192.168.1.91 and 192.168.1.93
I have configured the following settings to IP 192.168.1.91
After reboot, I check with LSOF and the server is still listening on all IP addresses
jsvc 18560 root 160u IPv6 111821064 0t0 TCP *:8088 (LISTEN)
jsvc 18560 root 167u IPv6 111821070 0t0 TCP *:8043 (LISTEN)
jsvc 18560 root 175u IPv6 111819898 0t0 TCP *:8843 (LISTEN)
jsvc 18560 root 331u IPv6 111821127 0t0 TCP *:29811 (LISTEN)
jsvc 18560 root 380u IPv6 111819048 0t0 TCP *:29812 (LISTEN)