Maintaining Full Stats with Omada
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
I recently installed an OC200 with four EAP access points. Everything configured fine but there are no statistics for users, etc. I suspect this is because I also need a TP-Link router. My question is once I receive a new TP-Link router (R605) will I start receiving statistics? I would like to continue using my HP Procurve POE switch. Can I still use the HP switch or do I also need to use and Omada compatible switch?
Thanks,
David
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
I had not seen these instructions. I get this message! What should I do? It says incompatible.
- Copy Link
- Report Inappropriate Content
Hey
That is just warning you that the settings will be reset once you start the upgrade process, once completed you will either need to
1. Manually setup the devices again
2. Restore from a backup config
Always best doing a backup first :)
- Copy Link
- Report Inappropriate Content
Hey
The App will only reflect what version of software you are running on the OC200 Controller. Once you update to v4 you will notice the app looks different also to reflect the newer version.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 3140
Replies: 23
Voters 0
No one has voted for it yet.