Omada Controller bind for MAC to the desired access point
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Is it possible to bind the device on MAC or IP-address to a specific access point? My printer, which is located on the first floor, constantly connects to the access point on the third floor and ignores the point on the first floor.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Strange one this but i had the same issue with a HP Printer. Turned out when it was scanning for wireless it searched for the SSIDs in accending order by channel. Namely it always tried to connect to the SSID on Channel 1 regardless of how far away it was.
I ended up swopping the channels around on the APs so that Channel 1 was on the AP near the printer, worked fine since..
Not the most elegant solution, but quick!
- Copy Link
- Report Inappropriate Content
Strange one this but i had the same issue with a HP Printer. Turned out when it was scanning for wireless it searched for the SSIDs in accending order by channel. Namely it always tried to connect to the SSID on Channel 1 regardless of how far away it was.
I ended up swopping the channels around on the APs so that Channel 1 was on the AP near the printer, worked fine since..
Not the most elegant solution, but quick!
- Copy Link
- Report Inappropriate Content
@Philbert Thanks, it also worked for Canon
- Copy Link
- Report Inappropriate Content
Happy days! Glad that worked for you!
Likely they both use the same type / vendor of wifi card and its very basic at best. Long as it works :)
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 1536
Replies: 3
Voters 0
No one has voted for it yet.