Eap225 wall plate does not power up
When plugging in the eap225 wall plate to a poe cable the led light does not flash (or do anything). I already have an eap225 outdoor and an eap225 ceiling working okay and have tried plugging this unit into their poe cables as a test but cannot get any life out of it.
I've tried reset and pressing the led button but no luck.
The unit was brand new boxed.
Any other suggestions?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Did you try a reset on the device? Or if you give it a few mins does the device start broadcasting the default SSID?
Might also be worth checking this directly into the switch via patch cable (not via wall trunking) to just make sure its not a cable run issue
Outside that, it could just be unlucky DOA device
- Copy Link
- Report Inappropriate Content
@Philbert thanks for the thoughts but I think I've exhausted all the tests I can try so will return it as a DOA.
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
@Beezer Yes - the problem was passive POE. Attached to a POE switch it works fine.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 1574
Replies: 4
Voters 0
No one has voted for it yet.