Is this feasible?
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Hi I'm using EAP110 as my AP then I will CPE210 as Client
The problem here is the branches of trees. May I know if CPE210 will be fine in this setting?
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
My concern would be more that the EAP110 may not be strong enough to penetrate the treeline, at a guess the CPE will be fine due to Db rating and just 25m of distance.
There is a likelihood the CPE will be fine, however the EAP may not be strong enough to send a good signal to the CPE, however the CPE should be able to reply ok to the EAP. In this scenario it should ideally be a CPE at both sides to try and brute force the signal through the treeline in both directions
Honestly, its a try and see scenario
- Copy Link
- Report Inappropriate Content
My concern would be more that the EAP110 may not be strong enough to penetrate the treeline, at a guess the CPE will be fine due to Db rating and just 25m of distance.
There is a likelihood the CPE will be fine, however the EAP may not be strong enough to send a good signal to the CPE, however the CPE should be able to reply ok to the EAP. In this scenario it should ideally be a CPE at both sides to try and brute force the signal through the treeline in both directions
Honestly, its a try and see scenario
- Copy Link
- Report Inappropriate Content
25 meters is under the signal range for the EAP110-outdoor in theory, the signal range for the EAP is also dependent on the actual environment. The trees may block the 2.4G signal of the EAP, cause the CPE210 can only receive to the front EAP with 2.4G. If the EAP110-outdoor is not good enough, you can also consider the CPE210 to set up the "Point to Point" internet transmission.
- Copy Link
- Report Inappropriate Content
Hi guys it's working
do I need to tweak more? like alignment, etc, etc.
- Copy Link
- Report Inappropriate Content
Hey
If you are getting a solid 55db SNR then I would advise you to just leave it as is, 55 is a reasonably solid strength. Seems a good result for you
Should this drop to around 70 then I would recommend changing things
Just leave it :)
- Copy Link
- Report Inappropriate Content
- Copy Link
- Report Inappropriate Content
Hi Guys,
I'm planning to change the EAP110 to another CPE210.
the EAP110 is quite spiky when another device is connected.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 1249
Replies: 6
Voters 0
No one has voted for it yet.