Gateway Default VLAN

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Gateway Default VLAN

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Gateway Default VLAN
Gateway Default VLAN
2021-08-18 20:22:50 - last edited 2021-08-19 21:54:02
Model: ER7206 (TL-ER7206)  
Hardware Version: V1
Firmware Version: 1.1.1

I'm trying to configure one port on our gateway to be an access port to a different VLAN, is this feature not implamented in the Software Controller? (running 4.4.4) I can see it if I reset the firewall back to stand alone mode but then I lose the dashboard.

  0      
  0      
#1
Options
1 Accepted Solution
Re:Gateway Default VLAN-Solution
2021-08-18 20:44:36 - last edited 2021-08-19 21:54:02

@Bruce_A 

Correct, multi-lan is only available in stand-alone mode for the the 7206 and 605 routers.  Not sure when or if it will be added to controller mode.

Recommended Solution
  1  
  1  
#2
Options
2 Reply
Re:Gateway Default VLAN-Solution
2021-08-18 20:44:36 - last edited 2021-08-19 21:54:02

@Bruce_A 

Correct, multi-lan is only available in stand-alone mode for the the 7206 and 605 routers.  Not sure when or if it will be added to controller mode.

Recommended Solution
  1  
  1  
#2
Options
Re:Gateway Default VLAN
2021-08-19 21:54:41

@1207 I will wait patiently then. Thanks for the info.

  0  
  0  
#3
Options