EAP110 in mixed mode 802.11 b/g/n

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

EAP110 in mixed mode 802.11 b/g/n

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
EAP110 in mixed mode 802.11 b/g/n
EAP110 in mixed mode 802.11 b/g/n
2021-08-28 11:54:40 - last edited 2021-08-28 14:18:07
Model: EAP110-Outdoor  
Hardware Version: V3
Firmware Version: 5.0.2

I notice in the documentation it says:

 

Data transmission rates 11n: up to 300 Mbps (dynamic)
11g: up to 54 Mbps (dynamic)
11b: up to 11 Mbps (dynamic)

 

 

Is there anyway I can configure my EAP110 to use just th e 802.11n mode ?

  0      
  0      
#1
Options
1 Accepted Solution
Re:EAP110 in mixed mode 802.11 b/g/n-Solution
2021-08-28 12:52:53 - last edited 2021-08-28 14:18:07

@Bebe1980 

 

On standalone mode its under RADIO SETTINGS

 

 

On the controller under the SSID settings, enable rate control and set this for 56


It will then kick B and G clients :)

 

Recommended Solution
  0  
  0  
#2
Options
2 Reply
Re:EAP110 in mixed mode 802.11 b/g/n-Solution
2021-08-28 12:52:53 - last edited 2021-08-28 14:18:07

@Bebe1980 

 

On standalone mode its under RADIO SETTINGS

 

 

On the controller under the SSID settings, enable rate control and set this for 56


It will then kick B and G clients :)

 

Recommended Solution
  0  
  0  
#2
Options
Re:EAP110 in mixed mode 802.11 b/g/n
2021-08-28 14:18:00

@Philbert 

 

Thanks... followed your advice and cut myself off laugh

 

So I've ticked the Disable the CCK rates as a compromise.

  0  
  0  
#3
Options

Information

Helpful: 0

Views: 330

Replies: 2

Related Articles