Configuring Router Cluster

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.

Configuring Router Cluster

This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Configuring Router Cluster
Configuring Router Cluster
2021-08-29 08:25:41 - last edited 2021-08-30 05:15:28
Model: ER7206 (TL-ER7206)  
Hardware Version:
Firmware Version:

Hi everybody,

 

i have a question to the TP Link Omada Router.

I need Hardware that is able to Build a Cluster with Failover like VRRP.

 

Did anyone know if that can be configured with the Omada Router ER7206?

 

thanks for your feedback!

  0      
  0      
#1
Options
1 Accepted Solution
Re:Configuring Router Cluster-Solution
2021-08-29 13:38:17 - last edited 2021-08-30 05:15:28

@Christian2705 

 

 

Hey

 

In short, No the ER7206 can only provide failover WAN connections on a single device, should the device itself fail there is no option / means to fall over to a secondary device.

 

The functionality to have clustering / HA for hardware in a VRRP setup is a lot more expensive than the ER7206, you need to look at the Cisco SDN

 

 

Recommended Solution
  1  
  1  
#2
Options
1 Reply
Re:Configuring Router Cluster-Solution
2021-08-29 13:38:17 - last edited 2021-08-30 05:15:28

@Christian2705 

 

 

Hey

 

In short, No the ER7206 can only provide failover WAN connections on a single device, should the device itself fail there is no option / means to fall over to a secondary device.

 

The functionality to have clustering / HA for hardware in a VRRP setup is a lot more expensive than the ER7206, you need to look at the Cisco SDN

 

 

Recommended Solution
  1  
  1  
#2
Options