Model: TL-SG2428P v1.0 firmware upgrade to 1.1.2
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
Anyone know where the release notes are for this firmware, I like to know whats changed - I'm being prompted that an update to 1.1.2 is available.
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Dear @biomed32uk,
biomed32uk wrote
Anyone know where the release notes are for this firmware, I like to know whats changed - I'm being prompted that an update to 1.1.2 is available.
Enhancement/Bug Fixed:
1. Fix the bug that Tx/Rx statistics of port is not accurate.
2. Fix the bug that IP address of L3 interface is not correct when the interface is down/up.
3. Fix the bug that bootutil can not be accessed via micro-USB port.
Notes:
1. For TL-SG2428P(UN) 1.0
2. This firmware is fully compatible with Omada Controller v4.3 or above.
- Copy Link
- Report Inappropriate Content
Dear @biomed32uk,
biomed32uk wrote
Anyone know where the release notes are for this firmware, I like to know whats changed - I'm being prompted that an update to 1.1.2 is available.
Enhancement/Bug Fixed:
1. Fix the bug that Tx/Rx statistics of port is not accurate.
2. Fix the bug that IP address of L3 interface is not correct when the interface is down/up.
3. Fix the bug that bootutil can not be accessed via micro-USB port.
Notes:
1. For TL-SG2428P(UN) 1.0
2. This firmware is fully compatible with Omada Controller v4.3 or above.
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 934
Replies: 1
Voters 0
No one has voted for it yet.