Router ER7206 and OC200 controller
This thread has been locked for further replies. You can start a new thread to share your ideas or ask questions.
hi
i received oc200 controller and er7206 Gb router
i configure router for my Lan, and when i adopt the router in the controler, i see the message "configuring", and the router's configuration seems to be reseted by the controler !
and of course my network is down !!
where is the problem ?
thanks
- Copy Link
- Subscribe
- Bookmark
- Report Inappropriate Content
Hey
When you are running the router in managed mode via the controller, you don't need / cant set anything locally on the router. All configurations need done via the Controller, then applied to the router. When the controller adopts the router it removes any local config and applies what you have set on the controller
Reset the router, adopt it into the controller and apply the settings for your WAN / LAN via the controller interfaces.
- Copy Link
- Report Inappropriate Content
Hey
When you are running the router in managed mode via the controller, you don't need / cant set anything locally on the router. All configurations need done via the Controller, then applied to the router. When the controller adopts the router it removes any local config and applies what you have set on the controller
Reset the router, adopt it into the controller and apply the settings for your WAN / LAN via the controller interfaces.
- Copy Link
- Report Inappropriate Content
thanks. after looking and reading some posts here, i have seen settings in the controler and i guess this settings went in the hardware you want to control.... of course !!
it was long to enter all NAT's setting, and change LAN IP adress at last time to be a router :!
thanks for respons
- Copy Link
- Report Inappropriate Content
Information
Helpful: 0
Views: 1040
Replies: 2
Voters 0
No one has voted for it yet.